Tag Archives: Masonry Contractor

Look For Tuckpointing Contractor Chicago

Tuckpointing a large structure can be a daunting task and should only be done by people who are not afraid of the heights, because you can end up in some scary places particularly along the lake where there are continuously strong winds.I strongly suggest you to visit Tuckpointing Contractor Chicago to learn more about this.

For example, let’s go over the tools you’ll require, of course awaiting work scale. You’ll need plenty of scaffolding, an elevator style cherry picker machine or a big jig lift. Of the three, a Jig lift is best because you can move it up and down easily to where you need it, and you don’t need to set it up as you would need with the other two solutions. You may find jig lifts that go up 60 foot boom, which is usually what you would need for most 4-story houses, as well as putting up an external elevator network that is connected to the roof and then descending from the top, which can sometimes be quite complicated if there are plenty of roof penetrations and the roof has to be flat to set up. The third option is scaffolding, but to put it up and tear it down requires a large investment in equipment and a lot of labour.

Let’s say the house is 4 floors or less so you’ll be using the Jig Lift to get your job done, other tools you’ll need is a blender, heavy duty grinders with 3/8 diamond wheels, grout sacks, tuckpointers and a hammer or rake. Make sure to use the lift properly qualified and use a safety harness so you don’t topple out of the bucket.

Start by using your grinder to ground out the joints as far as you can. Maybe a 10-foot square region mixes up the mortar and get ready to fill the joints after you get a good size portion ground out. If you are combining your mixture with a grout bag so it’s a little on the runny side so it quickly flows through your grout jar. You can only use your tuckpointer and trowel if you’re not confident using a grout bag. Using this approach can take a lot longer to make sure the mortar is solid and not runny at all. Inject or move the mortar uniformly into all the joints until they’re all filled in the field you’re operating on, then proceed with your striker or rake according to the look you like. Start with a brush after you complete the joints to remove any excess mortar and hit the joints again to finish them. But just so you realize hitting is much easier than raking, because it further seals the brick and brings a flatter finish to the side of your wall.

Repeat this process again and again until the job is done. Make careful to grit all the joints, because otherwise they will collapse even faster than the region you’ve grinded and finished. Tuckpointing can be a very long process but it must be achieved to preserve the integrity of your masonry walls. If you are still uncertain what a mason tuckpointing contractor would pay to complete the work for you.